minCam Manual
3
3. minCam Setup
3.1 Positioning of the system
System can be operated from an upright position (see figure 3.1.a) or on its side for greater
stability and control of the cable payout (see figure 3.1.b).
1. Loosen the pivot screw where the monitor (in the
Pelican case) connects to the cable reel (see
figure 3.1.c).
2. Position the monitor.
3. Open the lid on the case to reveal the monitor.
Functions as a sunlight visor.
4. Tighten the pivot screw to keep monitor in place.
Note:
Tighten the ball on the front to lock the
monitor
’s stand in place.
3.2 Power on
1. Verify that the camera head is connected
correctly.
2. Turn the light regulator to the middle position
(upright
– Figure 3.1.d)
3.
Press the “On/Off” switch.
The minCam system is ready to use.
Figure 3.1.c
– pivot screw controls swivel of
monitor.
Figure 3.1.a
– minCam system in upright position
Figure 3.1.b
– minCam system on its side
Figure 3.1.d
– light regulator is in the upright
position.
