Ratoc Systems EX30S, User Manual

Page: 8 / 20

eSATA ExpressCard/34
EX30S
User's Guide
1
2
3
4
5
6
Introduction * * * 2
-1. Package Contents * * * 2
-2. Layout * * * 2
-3. System Requirements * * * 3
-4. Specifications * * * 3
-5. Caution * * * 4
Setup * * * 5
-1. Installation on Windows System * * * 5
-2. To Verify Driver Installation (Windows) * * * 7
-3. Hot-plug tool (Windows) * * * 8
-4. Installation on Mac system * * *10
Connecting/Removing eSATA drive * * *11
-1. Windows * * *11
-2. Mac * * *15
Removing ExpressCard * * *16
-1. How to remove EX30S on Windows * * *16
-2. How to remove EX30S on Mac * * *16
Registration & Tech-Support * * *17
-1. Registration * * *17
-2. Tech-Support * * *17
Appendix * * *18
Contents
-1. Package Contents
Introduction
1
1
-2. Layout
1
eSATA Connector
ExpressCard Connector
Support Port Multiplier)
-3. System Requirements
1
-4. Specification
1
What's Port Multiplier(PM)?
?
..
..
..
.
-5. Caution
1
Setup
2
-1. Installation on Windows system
2
7
Found New Hardware Wizard
No, not at this time
Next
Install the software automatically(Recommended)
Next
Finish
Windows XP, Server 2003
Open Device Manager. (To open the Device Manager, go to Start -
Right click My Computer - Properties - Hardware - Device Manager )
1.
2.
On the device manager, double click on SCSI and RAID controllers .
Make sure if Silicon Image Silicon Image SiI
SiI3132 SATALink Controller
3132 SATALink Controller is registered
properly.
-2. To Verify Driver Installation -2. To Verify Driver Installation
2
If Silicon Image Silicon Image Si
SiI3132 SATA
3132 SATA
Link Controller Link Controller is shown without
yellow ! point, the driver is installed
properly.
What's HotPlug Tool
-3. HotPlug Tool (Windows)
2
Add or Remove Programs Control Panel
HotPlugTool Change or Remove Programs
OK
Start Program Hot plug tool
[A] Removing eSATA drive
Stop
[B] Change HotPlug Tool setting
HotPlug Tool Window
SCSI Disk
Device
-1. How to use HotPlug Tool (Windows Only)
3
Connecting/Removing eSATA drive
3
If the system recognizes the eSATA drive, the icon of HotPlug Tool will
Finish
Tool
Registration & Tech-support
5
Install HotPlug Tool
Uninstall HotPlug Tool
-4. Installation on Mac System
2
SiI3132_1.1.6u_Sil_Pkg
-2. Connecting/Removing eSATA drive on Mac
3
Removing ExpressCard
4
Safely Remove Hardware
Silicon Image SiI3132 SATALink Controller
-1. How to remove EX30S on Windows
4
-2. How to remove EX30S on Mac
4
Appendix
6
http://www.ratocsystems.com/english/
Software Update and Support
http://www.ratocsystems.com/english/
Technical Support
http://www.ratocsystems.com/english/contact/support.html
[A]
[B]
Power off Card
EX3
0S
EX3
0S
EX3
0S
EX3
0S
EX3
0S
EX3
0S