18
4. SCSI Configuration Utility
4-3. SCSI Configuration Utility Window
[PCI Burst Mode]
Default is
Enable
. If the PC does not support PCI Burst Mode, check
Disable
.
[Parity]
Default is
Enable
. If you connect the device which does not have parity check function, check
Disable
.
[Host SCSI ID]
SCSI ID No. for the CB31. Default is
7
. If you connect the device which can be not assigned other
than 7, change the ID.
[Disconnect]
Default is
ON
(checked) at all IDs. In case of
ON
,
the device is disconnected from SCSI bus
temporarily. While the device is disconnected, the SCSI PC Card can run other functions on the
SCSI bus efficiently.
[Command Queuing]
Default is
OFF
. If the queuing is required, check Queuing ID and enable Disconnect function.
[Translation]
Default is
20MB/s
.
Select the transfer rate by trying the choices shown until you find one that is
successful. If you connect FUJITSU MO(M2512A, M2513A), select
10MB/sec
.
If you connect the asynchronous device, select
Async
.
