The carburetor shall be cleaned on a clean site. First wipe off outer surface of the carburetor, and
internal parts can be cleaned with special carburetor cleaner or industrial gasoline. In addition to
impurities, note cleaning gasoline gel on part surface. Clean the parts with compressed air blowing,
cloth or paper that produces burrs shall not be used to wipe, in order to prevent re-pollution. It is
forbidden to poke through clogged hole by hard object such as steel wire, to prevent hole diameter
from changing to cause the change of carburetor performance, but it shall be washed off with gasoline
or compressed air.
Assembling:
Use compressed air before installation
The bottom removes dirt from the path.
Main metering jet
Float
Assembling:
Check if the float activity is free after
installation.
Main
nozzle
Assembling:
Blow in compressed air first to clean away the
dirt in the channel, and then mount it.
Float chamber
bolts
Oil drain
pipe
Gasket
Assembling:
Blow in compressed air first,
remove dirt from the internal
passages, and then install.
Carburetor
main body
Throttle
assembly
Damper
combination
Assembling:
First check the end wear and spring action
before installing.
Needle valve
Pressure
ring
Float pin
O-ring
Assembling:
Check that it is properly installed in the
slot.
Oil drain bolt of oil
bowl
Assembling:
Check for fuel leaks after installation.
Assembling:
Check for fuel leaks after installation.
