Rational MI-2091, Modification Instruction

Page: 4 / 32

1 | MI_2091: Installation energy optimisation board
4 / 32 MI_2091_V01
MI_2091_V01
Mounting the cable gland
The cable gland is required for the subsequent cable of the
energy optimisation control.
a The unit is disconnected from the power.
a
The cable gland is ready for use.
1. Remove the rear mounting plate for the cable gland on the rear of the unit.
2. Pierce the marked perforation with a suitable tool. If this is already in use,
choose another perforation.
3. Attach the cable gland with seal and plug to the broken out position.
4. Screw the mounting plate on.
>>
The cable gland is mounted.
Installing the energy optimisation board
CAUTION
Sharp edges on the housing
Risk of cuts on the housing when working in the electrical compartment.
Wear protective gloves.
NOTICE
Damage to the cable trunk and the control panel when removing the
control panel
The control panel is connected to the installation compartment by a cable
trunk.
Remove the control panel carefully in order not to damage the cable trunk.
Put down the control panel carefully and protect it against scratching.
NOTICE
Incorrect objects for opening the control panel
Do not use any sharp or pointy objects to press the control panel upwards.
This could damage the housing and gasket.