Rational 60.71.943, Installation Manual

Page: 14 / 20

V02 12/2013 - 14 -
A) Bottom unit:
Only SCC/CM units manufactured up to
08/2011
- Remove cover frame of care pump con-
tainer, byloosing the screw on the front
cross part of the cover frame pic 3 item A
- Fit fixing plates (pos. X) over lower part
of the legs Screw lower part of the leg
into upper part.
- Fasten leg (pos 12) together with the
reinforcement plates (pos. 10/11) to the
bottom of the unit.
pic B
- There must be a clearance of 150 mm
(6") underneath the unit. Adjust this dis-
tance with the height adjustable legs.
Additionally level unit at the site using
a spirit level. pic. 4
- Connect the water supply and check for
tightness
- Fix the unit at the site with the fixing
plates to the floor.
- Remove dome and left side panel. pic. 5
- Remove door holding device
pic. B item I
- Clean top cover.
- Remove screws of the top cover of the
unit from the position where holes in the
stiffening plate are.
- Put stiffening plate (pos. 1) onto the unit
and fix it with the screws removed from
top cover of the unit. pic. 6
- The stiffening plate can be used for units
with left or right hinged doors.
Damages based on installation not
complying with the directives given
hereunder are not covered by the war-
ranty terms.
The following Combi-Duo kits are
available:
top bottom
6x1/1 GN (E) 6x1/1(E)/10x1/1(E)
Art.-No.: 60.71.943
6x2/1 GN (E) 6x2/1(E)/10x2/1(E)
Art.-No.: 60.71.944
(E=electric)
Exact measurements and height of the top
rail please see dimensioned drawing as of
page 16 - 19.
Legend of dimensioned drawing:
1 = Height of top rail
2 = Height of drive in upper unit
3 = Height of drive in lower unit
4 = Drain height upper unit
5 = Drain height lower unit
For water connection, drain connec-
tion and power supply please refer to
installation instruction of units.
GB