Installation, first use and operation
Page 21
5.3 First use
Push the closed dispenser onto the wall-mounting plate from
above, until the locking tongue audibly clicks into place
Attach the drip tray
Open the dispenser again with the key
Mark the pump with the installation date. To do so, either write
on the label on the pump head while the pump is installed or
remove the pump and lie it down flat
See chapter 7. on how to remove it
Open the battery compartment and insert four new 1.5 V AA
Mignon LR6 batteries, observing the correct polarity (see
instructions on the battery compartment)
Close and lock the battery compartment
Insert the bottle, guiding it from below over the intake tube;
make sure the intake tube hangs freely in the middle of the bottle
and is not kinked
Place the bottleneck over the guide (on the bottom of the sensor
base plate)
Only for 1,000 ml dispensers: Centering device with a guide is
movable
Lift the bottle fastener and fasten it so that the bottle is firmly
held and cannot tip over
Remove the key and close the dispenser
