38
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read
the instruction book carefully
INTENDED USE
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting metal, a special protection
guard for cutting (accessory) must be used.
1. INSTALLING THE AUXILIARY HANDLE
(SEE A1, A2, A3)
You have the option of three working positions to
provide the safest and most comfortable control
of your angle grinder. The handle is screwed
clockwise into either hole on the sides of the gear
case.
2. HAND GRIP AREAS
Always hold your angle grinder firmly with both
hands when operating.
3. ADJUSTING WHEEL GUARD (SEE B)
For work with grinding or cutting discs, the
wheel guard must be mounted.
Wheel Guard for Grinding
The coded projection on the wheel guard (5)
ensures that only a guard that fits the machine
type can be mounted.
Open the clamping lever (11). Place the wheel
guard (5) with coded projection into the coded
groove on the spindle of the machine head and
rotate to the required position (working position).
To fasten the wheel guard (5), close the clamping
lever.
The closed side of the wheel guard (5) must
always point to the operator.
Note:
With the clamping lever (11) open the
clamp adjusting nut (10) can be adjusted to
ensure the guard is securely clamped after the
clamping lever (11) is finally closed.
Wheel Guard for Cutting
WARNING!
For cutting metal, always work
with the wheel guard for cutting (14).
The wheel guard for cutting (14) is mounted in
the same manner as the wheel guard for grinding
(5).
4. SPINDLE LOCK BUTTON
Must only be used when changing a disc. Never
press when the disc is rotating!
5. FITTING THE DISCS (SEE C1, C2)
Place the disc on the tool spindle and inner
flange (8). Ensure it is correctly located. For
grinding discs, the flange is fitted with the raised
portion facing towards the disc. For cutting discs,
the flange is fitted with the raised portion facing
away from the disc. Fit the threaded outer flange
(9) making sure it is facing in the correct direction
for the type of disc fitted. (see C1)
A1
A2
A3
B
