www.ratio.nl
AC16-BASICKIT /
Version: AC16-11
PREPARATIONS
A: 55 mm
B: 4,5 mm
C: 50 mm
3
I N S T A L L A T I O N O F T H E S Y S T E M I N T H E B O A T
Lay out the system components and cables. Check that the length of the cables is
sufficient when taking the placement of the system apparatus into consideration.
ASSEMBLY OF POWER INLET
1.
The electrical installation must be switched off during installation.
2.
Install the power inlet according to the stated instruction and directions
in the manual.
To install the power inlet, proceed as follows:
1.
Make a cut out in ship’s hull using the outline drawings.
2.
Position the gasket and inlet over the hull opening, align the mounting
holes and attach the inlet over the hull with screws. Install the inlet with
4mm stainless steel screws.
3.
SURFACE MOUNTING OF ELECTRICAL CABINET
Select a suitable place for fitting the electrical cabinet on a wall. Drill 2 holes of
4.5mm diameter and use 2 stainless steel screws with a flat bottom to mount the
electrical cabinet.
SURFACE MOUNTING OF DOUBLE WALL SOCKET
Select a suitable place for fitting the double wall socket. Drill 2 holes of 4.5mm
diameter and use 2 stainless steel screws with a flat bottom to mount the socket.
ASSEMBLY OF CABLES
Connect the internal cables to the system components, power inlet, electrical
cabinet and wall sockets. In order to release the cables connected to the system
devices, the accompanying dismantling tools must be used.
NOTE!
Ensure that the cables are relieved in the entry points to the devices when
assembling.
NOTE!
Connect all live devices in the boat that have a connection to earth, for
example via the water, to the earth-connection block (X0) located on the bottom
of the electrical cabinet.
S Y S T E M O V E R V I E W
A V A I L A B L E O P T I O N S
CABLE SPLITTER 1:3
Dimension (L, W)
90 x 50 mm
Voltage
250V AC
Current
20A AC
Weight
0,06 kg
