Pre-Installation Requirements
1. Internet Connection:
• Routed internet connection using DHCP
(Network must use private IP address ranges 10.X.X.X or 192.X.X.X or 172.X.X.X)
OR
• Cellular modem with data (available from RATH
®
)
2.
Laptop with a network connection for testing
3. Power Option:
2100-SVE Ethernet Extenders
4.
SmartView Controller, SmartView Display, and SmartView Camera
5.
YES and NO or DOOR OPEN and DOOR CLOSE buttons
Hardware Mounting
1.
Mount the SmartView Controller in the elevator using the provided adapter plate or mounting kit.
2.
Mount the Camera in the panel or ceiling of the elevator using the provided hardware. The Camera must be no
more than 15 feet from the Controller.
3.
Connect the Camera to the Controller using the provided USB cable.
4.
Mount the SmartView Display in the elevator panel. The Display must be no more than 20 feet from the Controller.
Note:
Reference Appendix A for Display part numbers and window thickness.
5
. Connect the Display to the Controller using the provided HDMI cable.
6.
Connect the Display power output (J10) to the SmartView Display power input using the provided cable.
Note:
The Controller output power (J10) is only compatible with the SmartView Display.
Note:
For use with the CE Elite Pi Display, you must order the Display with the proper software and also the correct
SmartView Controller part number.
7.
Connect the button designated for “YES” to the Controller terminal labeled “YES”.
8.
Connect the button designated for “NO” to the Controller terminal labeled “NO”.
Note:
Use 24AWG wire minimum and 18AWG wire maximum.
Powering Options
1. 2100-SVE Ethernet Extenders
a. Reference diagram on page 5 as a guide.
b. Place the main injector unit and UPS in the machine room or network room.
c. Connect the provided Ethernet cable from a routed network switch to the LAN/PoE port on the main injector.
d. Plug the included power supply into the UPS.
e. Use an existing single pair or run a single pair of wire from the main injector unit to the remote extender unit.
Note:
18AWG wire is recommended.
f. Using the provided RJ45 adapters, wire to pins 1 and 2 and connect the adapters to the Interlink port on the main
injector and Interlink port on the remote extender.
g. Connect the provided Ethernet cable from the PoE Out port on the remote extender to the Ethernet port on the
Controller Board.
Installation
Page 3
N56W24720 N. Corporate Circle Sussex, WI 53089
800-451-1460 www.rathmicrotech.com
