pg. 2
2100-CD9 Call Station with 900 mHz
Parts Listing Provided by Rath
1. Strobe
2. Rath SmartPhone Emergency Phone
3. Nema 4 electrical box mounted inside call station
4. Transformer -
277 volt to 120 volt transformer or 480 volt to 120 volt
Call Station Installation
1. Remove 12 security screws from the sides of unit.
2. Remove top cap from unit.
3. Pull front assembly away from back unit.
4. Disconnect the gray Wago connector (see diagram on next page).
5. If wall mount, mount to wall.
6. If pole mount, attach unit to pole using Pole Mounting Bracket (RP7700098A).
7. Remove the two nuts that hold the lower plate in place.
8. Remove the lower plate to facilitate the installation of the electrical supply conduit.
9. Connect the electrical conduit of the 120, 277, or 480 volt supply to the call station and run necessary
10. Place the lower plate back into the call station and reinstall the two nuts.
11. Install the battery on the lower left side of the call station (refer to the diagram below for correct
placement).
12. Install the transformer on the lower right side of the call station (refer to the diagram on the next
page for the correct placement).
5.
12V 60Ah Battery
6.
#10 Spanner Bit
The Rath Dusk2Dawn call station should only be installed by a qualified electrician.
Rath recommends that the call station be mounted so that the push button is less than 48 inches above
the ground to comply with the Americans with Disabilities (ADA) requirements. For ease of installation,
two people should perform the install.
7.
900mHz Base and Remote Station
www.rathsecurity.com
wires.
