8. USE WARNINGS
We recommend following the indications below in order to always work in safety conditions.
·
All the operations must be carried out complying strictly with the safety rules of the
country where the device is to be installed.
·
It is STRICTLY FORBIDDEN to smoke during the installation or adjustment operations of
the cutting unit.
·
The Customer undertakes to comply with and make his staff observe all the rules and
regulations in force concerning safety, prevention of accidents and health in the work
place. Therefore, the Customer assumes the responsibility to strictly follow all the rules
and regulations in force, as well as the special provisions in force in sport and public
installations the Customer declares to know after receiving all the relative necessary
information.
·
The cutting unit works also without its safety protective device. This
protective device must NEVER be removed.
·
Always check the resistance of the material to be cut and the kind of blade which is
being used.
·
The Customer shall equip his own personnel with all the individual safety protections
for the execution of the works, as well as with the ones which might be prescribed by
the Manufacturer due to specific danger conditions of the plant or of the area where the
personnel must work.
·
Do not make any adjustment while the blade is working or while the electric plug is
connected.
·
Always pay attention to the electric cable position to prevent it from being cut or
damaged by the blade.
·
It is allowed to assemble cutting unit SW12SM on machines O.E.M. on condition that their
original structure is not modified. Otherwise, the intervention must be certified by Rasor
®
.
Firstly make sure that the lines are able to feed the cutting unit correctly, in compliance with
the safety rules (for the feature required see par. 5).
We suggest installing a magnetothermic safety device before the cutting unit and check that
the ground circuit is effective. Before working on the feeding cable pull the plug out. Check
that electric connections and protections correspond to the driving
force and the plate data values (voltage and current), required by the
different electric circuits. Possible faulty ground connections make
the working conditions unsafe. Possible damages are not charged to
Rasor
®
. By referring to the EC 11-27/1 standard all the works carried
out by means of electric current must be performed by a staff, who
has been provided with all the devices required by the above-mentioned
standard. For the works carried out under voltage, it is necessary that
the employer certifies the suitability, against formative processes. As
the cutting unit SW12SM is supplied without plug, the user must use
a plug homologated in the country in which the cutting unit is used.
In the European Countries a Shuko plug is required (see picture 3). Never
change the lenght of the cable supplied. The cutting unit SW12SM is a
class II electric device, therefore it does not need any grounding cable.
WARNING
3
9. ELECTRIC CONNECTION
Enfocus Software - Customer Support
EN
24
Summary of Contents for SW12SM
Page 1: ...USE MANUAL english CUTTING UNIT MOD SW12SM ED 1 11 13 ...
Page 16: ......
