8
EN
8. USE WARNINGS
We recommend following the indications below in order to always work in safety conditions.
•
All the operations must be carried out complying strictly with the safety rules of the
country where the device is to be installed.
•
It is STRICTLY FORBIDDEN to smoke during the installation or adjustment operations of
the bench cutter.
•
The Customer undertakes to comply with and make his staff observe all the rules and
regulations in force concerning safety, prevention of accidents and health in the work
place. Therefore, the Customer assumes the responsibility to strictly follow all the rules and
regulations in force, as well as the special provisions in force in sport and public installations
the Customer declares to know after receiving all the relative necessary information.
•
The bench cutter works also without its safety protective device. This protective device
must NEVER be removed.
•
Always check the resistance of the material to be cut and the kind of blade which is being
used.
•
The Customer shall equip his own personnel with all the individual safety protections for
the execution of the works, as well as with the ones which might be prescribed by the
Manufacturer due to specific danger conditions of the plant or of the area where the
personnel must work.
•
Only one operator must use the bench cutter always standing behind the guide handle.
Do not make any adjustment while the blade is working or while the electric plug is
connected.
•
Always pay attention to the electric cable position to prevent it from being cut or damaged
by the blade.
•
It is allowed to assemble bench cutter SW100 on machines O.E.M. on condition that their
original structure is not modified. Otherwise, the intervention must be certified by Rasor
®
.
Firstly make sure that the lines are able to feed the cutter correctly, in compliance with the
safety rules (for the feature required see par. 5).
We suggest installing a magnetothermic safety device before the cutter and check
that the ground circuit is effective. Before working on the feeding cable pull the
plug out. Check that electric connections and protections correspond to the driving
force and to the plate data values (voltage and current),
required by the different electric circuits. Possible faulty ground
connections make the working conditions unsafe. Possible
damages are not charged to Rasor
®
. By referring to the EC 11-
27/1 standard all the works carried out by means of electric
current must be performed by a staff, who has been provided
with all t h e dev ices re qu ired by th e above -m en ti on ed
standard. For the works carried out under voltage, it is
necessary that the employer certifies the suitability, against
formative processes. As the cutter SW100 is supplied without
plug, the user must use a plug homologated in the country in
which the cutter is used. In the European Countries a Shuko plug
is required (see picture 3). Never change the lenght of the cable
supplied.
WARNING
3
9. ELECTRIC CONNECTION
