10
EN
After using the machine for some hours without
interruption, or if the machine cutting capacity
is reduced, it is necessary to sharpen the blade.
To carry out this operation, start the blade and
press sharpener “2” on the blade itself (by means
of push button “1”, as shown in picture 8) for 3-
4 seconds. Repeat this operation 2-3 times.
8
1
2
7
5
1
2
3
4
6
7
8
The sharpener button can be used only if the
transparent guard is completely lowered.
WARNING
13. LUBRICATION
9
WARNING
A
11. AIR PRESSURE GAUGE (OPTION)
The pneumatic scissors must be necessarily fed with
lubricated air with a pressure of 4-6 bar.
Rasor
®
offers, as option, a reduction unit filter with a
pressure gauge already calibrated with the quantity
of oil to be delivered as option.
The unit shown also in picture 7 is made up of:
1 - pressure reducer;
2 - valve to drain the condensate;
3 - drip-feed oiler unit;
4 - oil tank;
5 - pressure gauge;
6 - condensate tank;
7 - pipe fitting to connect the quick connection to
the network;
8 - pipe fitting to connect the quick connection to the scissor.
For the use and maintenance read the instruction sheet supplied with the filter.
12. SHARPENER ADJUSTMENT
Every 3-4 working hours, it is necessary to lubricate the
gear pair. In order to carry out this operation, remove
protective plug “A” located on the head of the
pneumatic scissors and fill it with the grease supplied.
Screw plug “A” again a few turns. Screw plug “A” a few
turns every 2-3 working hours (see picture 9).
The blade must never be dirty with grease or oil.
