EN
9
10. INSTALLATION AND USE
To install and use the cutting unit do as follows:
1) Fix the cutting unit to the machine by means of a flat or angle
bracket to mount on the upper part of the motor support of
the unit.
NOTE
The cutting unit can be installed in any position or angle: vertical,
uside down, lateral. The aluminium base does not have to touch the
machine table.
2) Lay down the material to be cut;
3) Connect the air hose to quick connection “A” (not supplied)
(see picture 4);
4) Set the pressure gauge (option) to 6 bar;
5) Put the material on the cutting base (see picture 5);
6) Adjust the moving front protection according to the thickness of the material to cut;
7) Enable the air remotely and carry out the cutting operation.
NOTE
It is possible to use cutting unit FP861V both keeping it fixed and
making the material slide and viceversa. It is important to keep the
material to cut as stretched as possible to prevent it from curling
WARNING
Do not use the two bolts which connect the motor to the
cutting part to fix cutting unit FP861V, otherwise the motor
shaft could break. In this case the warranty will be void.
4
5
A
11. AIR PRESSURE GAUGE (OPTION)
5
1
2
3
4
6
7
8
6
The cutting unit must be necessarily fed with lubricated
air with a pressure of 4-6 bar.
Rasor
®
offers, as option, a reduction unit filter with a
pressure gauge already calibrated with the quantity of
oil to be delivered as option.
The unit shown also in picture 6 is made up of:
1 - pressure reducer;
2 - valve to drain the condensate;
3 - drip-feed oiler unit;
4 - oil tank;
5 - pressure gauge;
6 - condensate tank;
7 - pipe fitting to connect the quick connection to
the network;
8 - pipe fitting to connect the quick connection to the scissor.
For the use and maintenance read the instruction sheet supplied with
the filter.
