EN
11
If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary
to replace it. In order to carry out this operation, use
butterfly key “1” and drift “3” locking the blade (shown
in picture 10).
In order to replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
the Local Law of the Country where the machine
is to be used (use of personal protection
devices);
2) Remove the fixed rear safety protection “A” (see
picture 11) by unscrewing the two slotted screws
“C” by means of a screwdriver (not supplied by
the manufacturer) and by removing the spacers
“D” as shown in picture 12.
Remove the mobile rear safety protection “B”
(see picture 11) by unscrewing the pin “E”
and by removing the two washers “F” as shown
in picture 12.
3) Insert the drift “3” (see picture 13) in hole “G”,
in order to lock the blade (the hole in the blade
must correspond to the hole in the structure).
4) Use a butterfly key “1” in order to unscrew the
nut “H” (see picture 13) and remove the blade
“L” (see picture 14).
5)
Replace the worn blade with the new one “2”,
being careful to center the blade on the gear,
in the correct position, and remember to
assemble it in order that the writing Rasor can
be seen by the operator.
6) Assemble all the components again and carry
out some cutting and sharpening tests.
14. BLADE REPLACEMENT
3
1
2
3
10
C
E
B
A
D
D
F
G
1
H
L
14
11
12
13
