13. LUBRICATION
Every 3-4 working days, it is necessary to lubricate the
gear pair. In order to carry out this operation, remove
protective plug “A” located on the head of the pneumatic
scissors and fill it with the grease supplied. Screw plug
“A” again a few turns. Screw plug “A” a few turns every
working day (see picture 10) when the machine is used
without interruption.
The blade must never be dirty with grease or oil.
14. BLADE REPLACEMENT
10
WARNING
A
If the blade is no more able to cut (even after repeating the
sharpening operation several times) it is necessary to replace
it. In order to carry out this operation, use butterfly wrench
“1” and drift “3” locking the blade (shown in picture 11).
In order to replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
Italian Legislative Decree 81/08.
2) Remove safety protection “B”, by unscrewing the two
slotted screws “A” by means of a screwdriver (not
supplied by the manufacturer), as shown in picture 12.
3) Insert drift “3” (see picture 13) into hole “C” in
order to lock the blade (the hole in the blade must
correspond to the hole in the structure).
4) Use butterfly wrench “1” in order to unscrew nut
“D” and remove blade “E” (see picture 14).
5) Replace the worn blade with the new one “2”, being
careful to center the blade on the gear, in the correct
position, and remember to assemble it with its sharp
side (the one with the writing Rasor) positioned
towards the external side of the pneumatic scissors.
6) Assemble all the components again and carry out
some cutting and sharpening tests.
12
3
1
2
3
13
C
1
14
A
A
B
1
D
E
11
EN
27
