8
EN
9. RESIDUAL RISKS
Even though the cutting unit is safe, operators must pay attention to preserve their safety
and that of others.
The cutting blade can work even when the protection device is disassembled.
8. USE WARNINGS
We recommend following the indications below in order to work in safety conditions.
•
All the operations must be carried out complying strictly with the safety rules of the
country where the device is to be installed.
•
It is STRICTLY FORBIDDEN to smoke during the installation or adjustment operations of
the cutting unit.
•
The Customer undertakes to comply with and make his staff observe all the rules and
regulations in force concerning safety, prevention of accidents and health in the work
place.
Therefore, the Customer assumes the responsibility to strictly follow all the rules and
regulations in force, as well as the special provisions in force in sport and public
installations the Customer declares to know after receiving all the relevant necessary
information.
•
The cutting unit works even without its safety protection device.
This protection
device must NEVER be removed.
•
Always check the resistance of the material to be cut and the kind of blade which is
being used.
•
The Customer shall equip his own personnel with all the individual safety protections
for the execution of the works, as well as with the ones which might be prescribed by
the Manufacturer due to specific danger conditions of the plant or of the area where the
personnel must work.
•
Do not perform any adjustment while the blade is working.
•
Always pay attention to the air pipe position to prevent it from being cut or damaged
by the blade.
•
It is allowed to assemble cutting unit FP120M on machines O.E.M. on condition that
their original structure is not modified. Otherwise, the intervention must be certified by
Rasor
®
.
•
The (inside) air pipe and connector diameter must be min. Ø 8 mm.
