EN
9
A
10. USE
3
To use the electric scissors manually, proceed as follows:
1) Lay the material to be cut on a table;
2) Connect the scissors to the power supply;
3) Put the material on the cutting foot;
4) Enable the enabling push button (see picture 3);
5) Push the electric scissors in the desired direction,
being careful to keep the material in front of them
as stretched as possible and preventing it from
curling in the front part of the scissors.
NOTE
The thrust on the electric scissors must be as uniform as
possible. To carry out linear cuts with precision (and to
follow predetermined paths), we also recommend using
the arrow point (see point “A” in figure 4).
11. MOTOR FUSE REPLACEMENT
In order to replace the motor fuse, proceed as follows:
1) Disconnect the scissors from the power supply;
2) Remove the screw from the fuse cover (see
point “A” figure 5);
3) Take out the glass fuse by means of the proper
pliers supplied (see figure 6);
4) Verify its integrity (see figure 7) and, in case, install a new
fuse checking the correct amperage;
5) Close the cover and tighten the screw.
WARNING
Never use the scissors when the fuse cover is open.
Risk of electric shock.
4
5
6
7
A