EN
11
14. LUBRICATION
Every 3-4 working hours, it is necessary to lubricate the
gear pair. In order to carry out this operation, remove
protective plug “A” located on the head of the electric
scissors and fill it with the grease supplied. Screw plug
“A” again a few turns. Screw plug “A” a few turns every 2-
3 working hours (see figure 11).
The blade must never be dirty with grease or oil.
WARNING
A
If the blade is no more able to cut (even after repeating the
sharpening operation several times) it is necessary to replace
it. In order to carry out this operation, use butterfly wrench
“1” and drift “3” locking the blade (shown in figure 12). In
order to replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
Italian Legislative Decree 81/08.
2) Remove safety protection “B”, by unscrewing the two
slotted screws “A” by means of a screwdriver (not
supplied by the manufacturer), as shown in figure 13.
3) Insert drift “3” (see figure 14) in hole “C” in order
to lock the blade (the hole in the blade must
correspond to the hole in the structure).
4) Use butterfly wrench “1” in order to unscrew nut
“D” and remove blade “E” (see figure 15).
5) Replace the worn blade with the new one “2”,
being careful to center the blade on the shaft, in
the correct position, and remember to assemble it
with its sharp side (the one with the writing Rasor)
positioned towards the external side of the electric
scissors.
6) Assemble all the components again and carry out
some cutting and sharpening tests.
15. BLADE REPLACEMENT
13
3
1
2
3
14
C
1
15
A
A
B
1
D
E
11
12
