Controls
Before driving your vehicle it is important to
familiarise yourself with the controls. Do not attempt
to drive the vehicle before reading the rest of this
Owner’s Manual.
Dashboard Description
1. Battery Indicator:
This indicator shows the level
of charge in the batteries. When the needle is in
the green zone, the batteries are fully serviceable
(adequately charged). If the needle is near the end
of the left side of the green zone, or if the red LED
(3) flashes a single flash slowly then the battery
needs recharging.
Note: When the vehicle is climbing a steep incline or
starting off, the level may drop momentarily; this is
normal.
2. Speed Control:
This controls the preset top
speed of your scooter. When the adjustment ring is
turned fully anticlockwise, this is the slowest speed
setting, marked by a tortoise. As the ring is turned
to the right the speed will increase to a maximum,
marked by a hare. Set the speed before you move
off. Do not adjust the speed control when the
vehicle is moving.
3. Power On Indicator:
When the ignition key is
inserted into the scooter and turned to the “on” or
“I” position, the red LED will illuminate after per-
forming a self-check at power up. Do not attempt
to dive the scooter until the red LED is constantly
illuminated signalling that the scooter is ready. If you
do not follow this procedure then it will be neces-
sary to turn the key to the off position (0) and back
to On (I) to restart the check procedure
Tip:
If the red LED (3) flashes continuously or in a
repeated pattern then there may be a fault. A key
to these fault codes can be found in the “Scooter
diagnostic functions” section of this manual.
A common “fault” is that the scooter has been left in
freewheel mode. This will be shown by the LED (3)
symbol flashing 9 times in a sequence then a pause
and repeated again. Turn the key to the “0” or off
position, disengage the free-wheel mode and turn
the key back to the on or “I” position. If the red LED
(3) flashes once every 5 seconds then the controller
has entered Sleep Mode. To reactivate the scooter,
the On/Off key will need to be turned to the ‘Off’
position and then back to the ‘On’ position.
4. Horn:
Press the button and the horn will sound,
if power is on. Release and the horn will cease.
8
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Rascal Vecta Sport Scooter Owner’s Manual and Service Record
