Raritan PXE Quick Setup Guide
5
QSG-PXE-1C-v3.5.0-E
255-80-0007-00 RoHS
b.
Default password:
raritan
(or a new password if you
have changed it).
5.
If prompted to change the default password, change or
ignore it.
To change it, follow onscreen instructions to type your
new password.
To ignore it, simply press Enter.
6.
The # prompt appears.
7.
Type
config
and press Enter.
8.
To configure network settings, type appropriate
commands and press Enter. Refer to the following
commands list. CLI commands are case sensitive.
9.
After finishing the network settings, type
apply
to save
changes. To abort, type
cancel
.
Commands for network settings:
The <ipvX> variable in all of the following commands is
either
ipv4
or
ipv6
, depending on the type of IP protocol you
are configuring. Replace the <ETH> variable with the word
'ethernet'.
General IP settings:
To set or
enable
Use this command
IPv4 or IPv6
protocol
network <ipvX> interface <ETH>
enabled <option>
<option> =
true
, or
false
IPv4
configuration
method
network ipv4 interface <ETH>
configMethod <mode>
<mode> =
dhcp
(default) or
static
IPv6
configuration
method
network ipv6 interface <ETH>
configMethod <mode>
<mode> =
automatic
(default) or
static
Preferred host
name (optional)
network <ipvX> interface <ETH>
preferredHostName <name>
<name> = preferred host name
IP address
returned by the
DNS server
network dns resolverPreference
<resolver>
<resolver> =
preferV4
or
preferV6
Static IP configuration:
To set
Use this command
Static IPv4 or
IPv6 address
network <ipvX> interface <ETH>
address <ip address>
<ip address> = static IP address, with a
syntax similar to the example below.
Example:
192.168.7.9/24
Static IPv4 or
IPv6 gateway
network <ipvX> gateway <ip address>
<ip address> = gateway's IP address
IPv4 or IPv6
primary DNS
server
network dns firstServer <ip
address>
<ip address> = DNS server's IP address
IPv4 or IPv6
secondary DNS
server
network dns secondServer <ip
address>
<ip address> = DNS server's IP address
IPv4 or IPv6
third DNS
server
network dns thirdServer <ip
address>
<ip address> = DNS server's IP address
To verify network settings:
After exiting the above configuration mode and the # prompt
re-appears, type this command to verify all network settings.
show network
QS Rule
Appendix B: Other Information
MAC Address
A label is affixed to the product, showing both the serial
number and MAC address.
If necessary, you can find its IP address through the MAC
address by using commonly-used network tools. Contact your
LAN administrator for assistance.
Identifying the Sensor Port
Warning: If you purchase Raritan's environmental sensor
packages, make sure you connect them to the correct port
on the PXE, or damages may be caused to PXE and/or
connected sensor packages.
