Raritan PX3TS Quick Setup Manual Download Page 9

 

PX3TS Transfer Switch Quick Setup Guide 

9

QSG-PX3TS-0A-v2.6-E 

 255-80-0032-00 RoHS 

 

Note: To use the Edimax EW-7722UnD or Raritan USB WIFI 
wireless LAN adapter to connect to an 

802.11n

 wireless 

network, the handshake timeout setting must be changed to 
500 or greater, or the wireless connection will fail. 

 

Built-in Wireless LAN Adapters 

If the Raritan product you purchased has been implemented 
with the following 802.11 wireless LAN adapter when shipping 
out of the factory, no USB wireless LAN adapters are required 
to make a wireless connection. 

Wi-Fi LAN adapter 

Supported 802.11 protocols 

HD-Wireless B/G 

 

 

Supported Wireless LAN Configuration 

If a wireless connection is preferred, ensure that the wireless 
LAN configuration of your PX3TS matches the access point. 
The following is the wireless LAN configuration that the PX3TS 
supports. 

  Network type: 802.11 A/B/G/N 

  Protocol: WPA2 (RSN) 

  Key management: WPA-PSK, or WPA-EAP with PEAP 

and MSCHAPv2 authentication 

  Encryption: CCMP (AES) 

Important: Raritan only supports specific wireless LAN 
adapters. Supported 802.11 network protocols vary 
according to the wireless LAN adapter being used with the 
PX3TS. See 

USB Wireless LAN Adapters

 (on page 8). 

 

Making a Wireless Connection 

The PX3TS can be connected to a wireless network. 

 

To make a wireless connection: 

Do one of the following: 

  Plug a supported USB wireless LAN adapter into the 

USB-A port on your PX3TS. 

  Connect a USB docking station to the USB-A port on 

the PX3TS and plug the supported USB wireless LAN 
adapter into the appropriate USB port on the docking 
station. 

See 

USB Wireless LAN Adapters

 (on page 8) for a list of 

supported wireless LAN adapters. 

 

QS Rule 

 

Additional Information 

For more information about the PX3TS

®

 and the entire Raritan 

product line, see Raritan's website (www.raritan.com). For 
technical issues, contact Raritan Technical Support. See the 

Contact Support page in the Support section on Raritan's 
website for technical support contact information worldwide.  

Raritan's products use code licensed under the GPL and LGPL. You can request 
a copy of the open source code. For details, see the Open Source Software 
Statement at  
(http://www.raritan.com/about/legal-statements/open-source-software-statement
/) on Raritan's website. 

 

Summary of Contents for PX3TS










Reviews: