3
OPERA
TION
Use ONLY PURASAN
®
Tablets.
DO NOT add any other chemicals or cleaning products to the
toilet or the treatment system. Raritan C.P. (part # 1PCP22) -
Cleans Potties is the only factory-recognized cleaning product
that may be used in the toilet.
REFILLING TABLET CARTRIDGE
(#41-135A)
When Error LED is flashing it is an indication tablets in the
dispenser are depleted to less than one tablet and refill is
needed.
Press No discharge button to stop cycling.
1 Remove all water by pressing “empty” button on the
panel before opening lid
.
2.
Turn off power.
3. With adequate ventilation available, unscrew tablet
dispenser lid.
4. Reload with two tablets into the cartridge.
5. Replace lid on Tablet Dispenser.
6. Turn on power
7. Press NO DISCHARGE mode button to return to
treatment mode
CLEANING:
Do not add any other chemicals or cleaning
products to the toilet or the treatment system.
REFILLING TABLETS
FIG 4
Insert Tablet
2 Tablets Only
OPERATION NOTES:
1. If start/stop button is pressed during first 20 seconds of
treatment cycle, motor will stop, A drain cycle will start to
empty out and water in the dispenser before stopping the
cycle. If waste level is higher than the low level sensor , next
cycle will start immediately.
2. A cycle can be terminated by pressing NO discharge mode
button. A drain cycle will run to empty out water in the tablet
before terminating cycle. Cycle will not restart until mode
is changed to treatment mode and Level is higher than low
level.
3. If cycle completes normal, there is a 8 second pause before
next cycle will start. During this pause none of the buttons
except No Discharge mode button is functional.
MAINTENANCE
CAUTION:
Do not load tablets into Tablet Dispenser until
Steps 1-6 are completed.
1. Remove crossover cap (see FIG 12; #25) from Treatment
Unit tower. Pour 3 gallons (11.5 liters) of water into treat
-
ment unit. Replace crossover cap.
2. Turn on water to the Water Valve.
3. Turn on power to unit.
4. Priming: Press and hold “FILL” button until water reaches
to the water line on the Tablet Dispenser. Press and hold
“EMPTY” button until Tablet Dispenser and 3/8” tube
to Treatment Unit is empty.
5. Operate the system. Check water level in the cartridge and
make sure water is rising to the mark. If starting for first
time or if water does not rise to the mark, see instruction
in Programming section to adjust timing.
6. Check for leaks.
7. Load the Tablet ( see refilling tablet section).
INITIAL START-UP - AFTER ALL INSTALLATION STEPS ARE COMPLETE
CLEANING OF TANK CHECK VALVE(41-156)
AND ½” HOSE
A. Every 50 cycles, clean ½” hose and check valve
(41-156) on tank using following procedure:
1. Press fill button till water fills up entire ½”
hose just below tablet dispenser
2. Press and hold “empty” button until all hoses up to
check valve on treatment tank are empty.
3. Repeat steps 1&2 three more times.
B. Every time tablets are refilled, check valve assembly on
the treatment tank must be cleaned.
1. Close seacocks
2. Close hose clamp completely. Remove check valve
assembly and thoroughly clean assembly with warm
water. Make sure check valve plunger is moving by
actuating with a paper clip. If check valve is stuck, replace.
L519 _0919jlc
