background image

1

PURASAN

® 

EX Hold n’ Treat

OPERATION, MAINTENANCE AND INSTALLATION INSTRUCTIONS

(Models PST*EX  [*specify 12,24] Manufactured after December 2013)

 

The PURASAN

®

EX is a U. S. Coast Guard Certified Type I Marine Sanitation Device for use on unin

-

spected vessels 65 feet and under. It must be operated within navigable waters inside the three mile limit 

that are not declared Federal No Discharge Zones (NDZ) by the U.S. Environmental Protection Agency 

(EPA).  Other countries - check with local authorities.

The PURASAN

®

EX is designed for recreational use and accommodates most marine toilets.  The 

PURASAN

®

EX is available in 12 or 24 VDC. 

DESCRIPTION:

Each time the transfer pump cycles an equal amount of previously treated waste is discharged. The pump

-

ing action of the transfer pump moves the waste through the 

PURASAN

®

EX

 and out. 

Water is diverted to the Tablet Dispenser during the treatment cycle, creating a halogen solution during hold 

time. After the hold time, the Drain Manifold and Air Pump turn on and the solution drains into the Treat

-

ment Unit.The first chamber macerates to reduce particle size and uniformly mix the waste with injected 

halogen solution. The second chamber mixes to ensure uniform treatment of its contents. 

              

THE FOLLOWING ARE CAUTIONARY STATEMENTS THAT MUST BE READ AND 

FOLLOWED DURING BOTH INSTALLATION AND OPERATION

  

 

 WARNING:

  Raritan Engineering Company, Inc. recommends that a qualified person or electrician install this product.  

Equipment damage, injury to personnel or death could result from improper installation.  Raritan Engineering 

Company, Inc. accepts no responsibility or liability for damage to equipment, or injury or death to personnel 

that may result from improper installation or operation of this product.

   WARNING:  HAZARD OF SHOCK AND FIRE

   

 

Always use recommended fuse or circuit breaker and wire size.  

 

 

 

 

 

   

WARNING:  HAZARD OF FLOODING - 

When leaving the boat unattended always be sure seacocks are closed.  Any 

installation made below waterline should have double hose clamps securing lines.  

The halogen disinfectant 

is corrosive to aluminum, copper and steel.  The plumbing system must not include any aluminum, 

copper or steel fittings, piping or holding tanks. 

IMPORTANT SAFETY INSTRUCTIONS FOR HANDLING PURASAN

®

 TABLETS AND SOLUTION 

 

 PURASAN

®

 EX disinfecting tablets are a strong oxidizing agent and highly corrosive. Use or contact 

with oil, acids, petroleum products, reducing agents or other chlorine compounds such as swimming 

pool tablets, is extremely dangerous

 

 

Fire or explosion could result. Improper use of this tablet may cause personal injury or property damage. 

Tablets may be fatal if swallowed and tablet dust is irritating to the eyes, nose and throat. Keep out of 

reach of children and do not allow tablets or solution of tablets to contact skin, eyes or clothing. Handle 

and store tablets as per instructions provided with packaging. Contact Raritan if handling instructions 

are missing. Store only in sealed original container in well-ventilated area. Read tablet container label 

carefully prior to use. It is unsafe and violation of Federal law to use tablets in a manner inconsistent 

with its labeling.

 WARNING:

 WARNING:

The Hold n’ Treat is designed to integrate both a Type I and Type III MSD (Marine Sanitation Device) to 

provide the user with a system that will be legal in all areas.  

All waste is stored in a holding tank and the treatment mode will determine how the waste is processed. 

This system eliminates the need for pump-out stations in most areas.

L519 _0919jlc 

Summary of Contents for PURASAN EX Hold n' Treat

















Reviews: