Raritan EMX2-111, User Manual

Page: 83 / 565

Chapter 5: Using the EMX
71
Number Example information
The selected target is the environmental sensor whose ID
number is 9 (SENSOR 9).
The selected environmental sensor's reading is 22 .
The word "MASTER" indicates the EMX is the master
device in a cascading configuration.
For a slave device, it shows "SLAVE" instead.
Note: As of release 3.3.10, the "MASTER/SLAVE"
information is no longer available in the bridging mode,
but remains available in the port forwarding mode.
The measurement unit is (degrees in Celsius).
To display the environmental sensor information:
1. Press the MODE button until this product enters the Sensor mode,
as indicated by "SENSOR" at the top of the LCD display.
2. Press the Up or Down button until the desired environmental
sensor's ID number is displayed.
For example, "SENSOR 1" refers to the sensor #1 listed on the EMX
web interface. "1 SENSOR 24" refers to the #124 sensor.
3. The LCD display shows the reading or state of the selected sensor in
the middle of the LCD display.

When showing a numeric sensor's reading, the appropriate
measurement unit is displayed to the right of the reading.
Measurement
units Sensor types
% A relative humidity sensor
A temperature sensor
m/s An air flow sensor
Pa An air pressure sensor
NO measurement
units For an "absolute" humidity sensor, the
measurement unit is g/m
3
, which cannot be
displayed on the LCD.

Available states for a state sensor: