STORAGE
When boat is not in use, flushing the system with
fresh water will help minimize odors and reduce
mineral and scale build-up.
WINTERIZATION
CAUTION: Use only non-toxic antifreeze.
Improper winter lay up is a major cause of marine
toilet failures.
1. Close the intake and discharge seacocks.
Disconnect and drain the intake and discharge
hoses. Winterize seacocks and hoses.
2. You will need two buckets, three feet (1m) of
3/4" (19 mm) hose, three feet (1m) of 1 1/2"
(38 mm) hose and a quart (1 liter) of non-toxic
antifreeze.
3. Prepare one half gallon (1.9 liters) of an
antifreeze/water mixture in a bucket (refer to
the antifreeze instructions for antifreeze/water
ratio). Place intake hose in this bucket. Place
discharge hose into the empty bucket. Pump
toilet until antifreeze has circulated and is
being discharged.
4. Antifreeze should remain in toilet until
recommissioning. This will protect
intake and discharge sides of the pump.
Pouring antifreeze into the bowl will
only protect the discharge side of the
pump, allowing the intake side to
possibly freeze.
NOTE: Holding tanks, secocks and
treatment systems will have to be
independently winterized, stored and
recommissioned (see manufacturer’s
instructions).
RECOMMISSIONING
When danger of freezing has passed,
reconnect intake hoses and open seacock.
(Failure to open seacocks and attempting to
operate unit can cause damage to toilet.)
Flush out the antifreeze into a bucket. Be
sure to dispose of antifreeze in accordance
with local, state and federal regulations.
Fig. #3 MOUNTING TEMPLATE
13 1/2"(34.3cm) (Hi-Boy Bowl)
9" (min.)
(22.9cm)
7 7/16" (18.9cm)
Wall or
Bulkhead
5 1/2"(14cm)
(Std. Bowl)
7 1/2" (19cm)
(Hi-Boy Bowl)
5 5/16"
(13.5cm)
2 21/32"
(6.8cm)
3 3/16"
(7cm)
Reconnect discharge hose. Check connections for
leaks with several test flushes. Follow "Operation"
instructions.
TROUBLESHOOTING
Before attempting repairs be sure you have studied
this manual and parts list thoroughly and have checked
the terms of the Limited Warranty.
If you have questions please contact our Technical
Support Department in either Millville, NJ or Ft.
Lauderdale, FL.
CAUTION: Before working on toilet or whenever
leaving the boat unattended be sure that both
intake and discharge seacocks are closed.
Ordering replacement parts:
Individual parts and
a repair kit (#CKRK) are available through your
dealer, distributor, direct from the factory, or at
www.raritaneng.com.
Units requiring extensive repairs may be returned to
the Millville, N.J. or Fort Lauderdale, FL. office.
Instructions, including name, address and phone
number MUST accompany returned units to ensure
proper handling.
13"(33cm) (Std. Bowl)
