Using a 5/32” hex driver fully inserted into the retention mechanism screw, tighten the retention
mechanism screw by turning the driver clockwise until a hard stop has been reached.
Your CPU now is correctly installed. If you have a second CPU, repeat this process for the other
socket.
REMOVAL
Removal of the heatsink and CPU follows the installation procedure given above, only in reverse.
Start with step 5, turning the hex driver counterclockwise, and end with step 1, replacing the socket
protective cover into postion over the socket.
WARNING:
Before attempting to remove the heatsink, ensure the mainboard has been placed
horizontal to the ground. Failing to do so could cause the CPU to fall out of the socket, causing
damage to the CPU, the CPU socket, and any components located below the CPU.
© 2017 - 2019 Raptor Computing Systems, LLC
C1P9S01 User's Guide Version 1.00
All Rights Reserved
15
Illustration 7: Tighten Retention Scew until Hard Stop