7. Operation
7.1 Waste oil collection:
7.1.1. Before start working always check with level indicator pos. 7 how much
waste oil is within the container. In case the container is too full, please
empty first as explained in chapter
7.1.2. Place the unit below the oil drain outlet. Push up the collection pan as far
as
possible and secure with clamping screws.
7.1.3. Open the filler valve Pos.3, and air inlet valve at Pos. 6, by unscrewing
them
until the venting slots are unblocked.
7.1.4. Now waste oil flow in.
7.2 Emptying of the container
7.2.1. Place the unit besides the waste oil collection tank. Push down the
collection
pan as far as possible and secure with clamping screws.
7.2.2. CAUTION! It is indispensable to close the filler valve Pos. 3, and air inlet
valve at Pos. 6..
7.2.3. Insert male adapter (with hose Pos. 11) into the female adapter Pos: 15
and
fix it.
7.2.4. Open emptying valve (with hose pos.11).
7.2.5. Establish a compressed air connection to Pos. 6 by using a tyre
inflator. Fill the container with 0,5 bar. Container will be cleaned out
7.2.6. After the container is empty disconnect the compressed air and let the
pressure within the container completely leaking out of the container.
7.2.7. Close drain valve (with hose Pos. 11)
7.2.8. Clamp in hose Pos. 11 to the holder Pos. 13
8. Maintanence and trouble shooting
8.1 Before every use all parts of the unit which are getting in contact with
the medium have to be checked carefully if there are leaks or damages,
and if so eliminate.
8.2 In case of spilled waste oil pick it up with suitable means and remove it
properly. No waste oil may pollute soil or sewerage system.
8.3 If necessary, inside of container can be cleaned by filling in and
emptying Diesel.
9. Disposal
9.1Completely empty all parts of the equipment ( hoses, pumps , tanks , etc
) and given case blown out with air .
9.2 dangerous parts of the appliance must be made unusable f.e. perforate
6
+49 (6158) 92980-0
