Cable
Lug
Loop
8
How to remove all tags from safe:
1. Open the RAPiD
®
Safe with either the key or a previously programmed RFID tag
or key code. Locate the red program button. Press and hold the button for five
seconds to erase all tags from the safe. All five red LEDs will begin to blink in
sequence. (The safe does not allow individual tags to be removed. They must all
be erased at one time. The intended RFID tags can then be reprogrammed back
into the safe with the instructions above.)
NOTE:
To abort the erase procedure, press the “H” button on the lid of the safe
or do not touch anything and the erase procedure will automatically abort after
10 seconds and return to normal operation.
Test RFID tags and the key code to
confirm they are operational.
2. To confirm erasing procedure, press and release the program button again.
All five LEDs will blink three times to visually confirm all RFID tags have been
removed. All RFID tags will no longer work until they are programmed back into
the safe with the instructions in the “How to Program Your RFID Tags” section.
Closing the Safe
The safe has a latch closure sensor that will illuminate the LED in the keypad
when the lid is closed.
Green – Latch has fully closed.
Blinking Red – Latch has NOT fully closed.
Press lid down to fully close or re-open and check for interference.
Security Cable
The RAPiD
®
Safe includes a security cable that can be looped around a
stationary object. With the safe lid open, feed the lug end through the loop end
and place the lug end of the cable into the security cable slot and close the lid.
16-HMC-0113 Instructions Rapid Safes 2600KP-2700KP - INSIDE PGS-4A.indd 8
8/25/16 4:14 PM
