1
General
1. Overview Components
Glass bottom
The post curing unit is intended for curing
components manufactured in the DLP process.
When equipping the unit, ensure that
XXX
- the components are clean and dry.
XXX
- the components should not be stacked or
XXX-
overlap each other.
XXX
- the components should not cast shadows
XXX-
over each other.
XXX
- the maximum component height of 60 mm
XXX-
should not be exceeded.
For proper curing of the components, observe
the specifications of the material manufacturers.
For proper operation of the post curing unit,
keep the exposure chamber clean and dust-free.
(See the cleaning instructions on page 3.)
•
•
•
•
2. General Information
For safety reasons, the unit should not be
opened during curing process.
In case the curing result deviates from the
desired result, cure again or contact Customer
Services.
Read the full operating instructions for safe work
and best results with the post curing unit.
•
•
•
Back plate
Operating instructions
