Vega
I
Restoring BIOS Parameter
32
33
www.raondigital.com
Charging the Battery
The battery is being charged while in use and the charging process
can be confirmed with the Blue LED at the bottom right.
The LED light is ON in charging process and will go OFF when the process is finished.
It will take about 4 hours to be fully charged once the battery is completely discharged.
The charging LED light goes OFF after completing the charging process
and the LED light will be ON again if the AC Adapter is connected for additional charging.
In general, the battery will be only charged up to 80% during the initial charging process.
When the AC Adapter is reconnected, it will try to recharge if the battery
is not fully charged by checking the charging voltage.
It will take about 4 hours to be fully recharged once the battery is completely discharged.
Restoring BIOS Parameter
The Parameter for BIOS is maintained by means of a separate Backup power.
If the Parameter is not being used for long time however, or
if the BIOS Parameter is setup inappropriately, there could be a system malfunctioning.
Take the following steps to restore.
1. Discharge of the CMOS Battery - Release the battery and using a pen,
press the CMOS Reset Hole in the back for 10 seconds.
2. When the product is turned ON, the screen
will read‘CMOS Check Sum Error’and will be halted.
3. Press the ‘Del’ Key to get into the BIOS Setup screen.
From the Setup screen, press the keys to use the direction key
and change the Mouse Mode to the Cursor Mode.
4. Execute the Load Optimized Default.
5. Execute booting after Save & Exit Setup.
Alt
