Ransomes HR3806, Parts And Maintenance Manual

Page: 22 / 134

GB-20
RANSOMES HR3806 Series: DZ
MAINTENANCE AND PARTS MANUAL
CUTTER DECK ADJUSTMENTS
7 CUTTER DECK ADJUSTMENTS
7.1 HEIGHT OF CUT ADJUSTMENT
The cutting height is determined by the position of
the blades in relation to the caster wheels. Changes
to this height are made at (4) points and can be
made in any order. Make adjustment selections for
each deck from the height of cut chart for that deck
included in this section.
NOTES
– Cutting height must be set the same for all
three decks.
– The actual height may vary slightly from
the chart value because of tire pressure or
condition.
HEIGHT OF CUT ADJUSTMENT (CENTRE DECK)
1. Raise the deck.
2. Remove the quick pin Q from the top of the
caster wheel pivot spindle
3. Remove the caster wheel from caster
support M .
4. Select either Position 1 or Position 2 for
wheel mounting bracket. To change,
remove (4) mounting bolts R , move to the
alternate location and bolt in place.
5. Place the selected size and number of
spacers below the caster support. Both A-
size (6.5 mm) and B-size (12.5 mm)
spacers are provided. Place the remaining
spacers above the caster support.
6. Replace the quick pin.
7. Place pin P into the proper hole of bracket
for the selected height of cut.
CENTER DECK HEIGHT OF CUT CHART
Fig.18
Fig.19