Ransomes G - PLEX WD series, Service Course Manual

Page: 9 / 181

OPERATION
840228
Read and familiarize yourself with the
following warnings
before operating the unit.
WARNING
• This is heavy equipment. Improper
use, or operating the unit in areas
that may cause it to overturn, could
cause serious injury or death of you
the operator or bystanders.
• READ and understand the
operator’s manual before
attempting to operate this unit.
• Allow ONLY trained and authorized
persons to operate this unit.
NEVER allow children to operate
this unit. Local regulations may
restrict the age of the operator.
• Never operate the unit while people,
especially children, or pets are
nearby.
• Keep in mind that the operator or
user is responsible for accidents or
hazards occurring to other people
or property.
• BEFORE using the unit, always
inspect it for problems. If something
is wrong,
DO NOT USE IT . Fix the
problem before using the unit to
prevent possible injury.
• WHILE using the unit, if something
is found to be wrong, STOP using
it. Fix the problem before the unit is
used again.
• Run the engine ONLY where there
is enough fresh air to prevent the
buildup of carbon monoxide fumes.
Carbon monoxide is colorless,
odorless and deadly.
NEVER run
the unit in an enclosed space
where exhaust fumes will collect.
• NEVER use the unit in or near an
area where there may be explosive
dust or fumes. The electrical and
exhaust systems of this unit will
make sparks that can ignite
explosive materials.
• ALWAYS use good judgement
when operating on or near hills or
slopes.
NEVER start or stop
suddenly, you may cause unstable
operating conditions.
NEVER
change directions abruptly or make
sharp turns on slopes.
ALWAYS
drive straight up and down the face
of slopes,
NEVER across the face.
• When refueling, ALWAYS stop the
engine and do not allow sparks or
open flames anywhere near the
unit.
DO NOT overfill the fuel tank.
Fuel is extremely flammable and
highly explosive under certain
conditions. Clean up any spilled
fuel and allow the vapors to
dissipate before operating the unit.
Store fuel in containers specifically
CONTROL ARM ADJUSTMENT
Support the control arm to avoid a sudden drop
while adjusting its height. Loosen the
Locking
Lever to allow the steering wheel and control
arm to be adjusted up or down. Tighten the
locking lever when steering wheel is at the
desired position.
1
Figure 21
1. Control Arm Height Locking Lever
WARNING
• DO NOT attempt to adjust the control
arm position while the unit is moving.
Operator may loose control, causing
possible injury to themselves or
bystanders.
HYDRAULIC PUMP BYPASS VALVE
The Bypass Valve allows the unit to be pushed
or towed. Turn the handle on the bottom of the
pump counterclockwise (as viewed from the
bottom of the pump) to open the valve. After
moving the unit, close the valve by turning the
handle clockwise.
1
Figure 22
1. Bypass Valve Handle
NOTICE
• The bypass valve must be tightly
closed for normal operation or a
significant loss of speed will occur and