TF2005101-OG-01 ENG
Page 12 of 17
20190618 V.2
2. Attach thermocouple (D) as per right drawing and tighten the nut
(Y).
3. Insert burner through the bottom of the stand (1), in between wind
shield (F) (side with rectangle lip) and burner support bar (G).
4. Unscrew the pre-assembled nut from the threaded pin of the burner
(2). Align timer control box (3) to the timer box support bar (11) and
fix it with 2 pieces M6x12 screws by going through the support bar
(11) and then to the time box (3). Then align burner (2) base to
burner support bar (G).
5. Align holes on heat shield (4) with threaded pin and alignment pin
of burner (2) through hole in burner support bar (G), then through
small hole of heat shield (4). The alignment pin on bottom of burner
(2) must be inserted through the large hole of the heat shield (4),
tighten hex nut onto bolt of burner (2). Finally, fix the support bar
(11) to legs of stand with 2 pieces M6x12 screws by going through
the holes on legs and then through the holes of support bar (11).
Tighten the screws with 2 pieces M6 nuts.
6. When transporting or storing LP cooker without tank attached, hook
regulator onto burner or cooker stand to prevent damage to
regulator.
7. Attach the Lid Handle (6A) to the Lid (6) by using 2pcs Bolt M6 x 10
(C) and Nut M6 (D).
Using Your Thermometer
Check the thermometer before each use by inserting into a pot of boiling
water and ensuring that it registers approximately 212°F +/- 20°F (100°C
+/- 10°C). If it does not function properly, obtain a replacement
thermometer specified by the manufacturer before using the appliance.
Prior to lighting, position thermometer clip so that at least 2.75
” of
thermometer tip is submerged in oil. Reposition thermometer as
necessary to cook. Continue to use thermometer until burner is turned
off.
6
6A
