Ranger Fisherman Series, Owner'S Manual

Page: 54 / 77

Electrical System
54
too much time elapsed after entering in the user code before pressing the
“1” and “4” . Turn the system off by entering in the code and press stop.
After the LED is not lit by the stop button, start at the beginning of this
section again.
After the flashing of the stop LED is obtained, enter in the new four
digit number followed by the start button, and then re-enter the four digit
number followed by the start button.
“X-X-X-X” “Start” “X-X-X-X” “Start”
After pressing the start button the second time, the system will go into
accessory mode. If it does not enter accessory mode, type the current user
code in and press the stop button then proceed to the beginning of this
section.
Navigation Lights
The switch labeled “Nav./Anchor” on the bow and console keypads
controls the operation of the navigation lights. On the first key press, the bow
navigation and stern anchor lights will turn on. On the second press, the bow
lights will turn off and the anchor light will remain on. On the third key press,
the anchor light will turn off.
Aerator System
There are two livewell buttons, one labeled “1” and the second labeled
“2”. livewell button “1” is for the main well and “2” for the bait well. Pressing the
buttons once will turn on the pump and pressing a second time will turn off the
pump. While the pumps are running, you can set the livewell timer for a
desired run time for the pumps. The timer can be adjusted in three
increments, “L, M, and H”. The “L” setting is 1 minute on and two minutes off.
“M” is 5 minutes on and 1 minute off. “H” is 15 minutes on and two minutes
off.
Fuel System Functioning Indicator
The LED with the fuel pump located next to it is a fuel functioning
indicator. This LED will tell you if a short is present between the sending unit
and the gauge.
Bilge System
The switch labeled with an image of the water leaving the sump of the
boat controls the bilge pumps in the boat. Pressing this button once will
activate a manual bilge pump; pressing again will activate the auto bilge and
the manual bilge; pressing again will turn off all bilge pumps. The automatic
bilge pump float switch only has power when the main circuit breaker is in on
position. The float switch is located in the sump of the boat.
Interior Lights
Pressing the button with the light bulb activates the interior lights on