4
Item #
Description
Qty.
Item #
Description
Qty.
1
Retaining Ring M20
2
10
Piston Roller Bearing
1
2
Washer
2
11
Handle Yoke
1
3
Front Wheel
2
12
Grease Fitting
1
4
Retaining Ring M15
2
13
Set Screw (Handle)
1
5
Saddle
1
14
Yoke Retaining Bolt & Washer
2
6
Block Linkage & Split Pin
1
15
Handle Lever “A”
1
7
Power Unit Assembly
1
16
Bolt M6 x 35
1
8
HHN M12 & Lock Washer
7
17
Handle Lever “B”
1
9
Rear Caster Assembly
2
18
Universal Joint Assembly
1
DESCRIPTION OF PARTS
DESCRIPTION OF PARTS
TROUBLESHOOTING
PROBLEM
ACTION
1. Unit will not lift load
Purge air from hydraulic system by following procedure
under OPERATING INSTRUCTIONS.
2. Unit will not sustain load or feels “spongy” under load.
Purge air from hydraulic system as above.
3. Unit will not lift to full height.
Purge air from hydraulic system as above. Check to be sure
oil level is not too high or low.
4. Unit will not lower completely.
Check oil level. Make sure not over
fi
lled.
5. Handle tends to raise up while the unit is under load.
Pump the handle rapidly several times to push oil past ball
valves in power unit.
6. Unit still does not operate.
Contact Parts & Warranty Department.
