Spin Mode / DYNAMIC, AL1, AL3, AL4
1. Once the correct wheel data and
FUNCTION
have been
programmed, lower the hood to begin the spin mode.
Before initiating the spin sequence, make sure that the
hub nut is secure and engaged on the arbor threads by
at least four (4) full turns.
2. After the hood is lowered, or the
START
button is
depressed, the wheel will spin for approximately six
seconds then stop automatically.
3. After the wheel stops, weight readings for each side of the
wheel (
INNER
and
OUTER
) will appear in the center display
screen.
4. Turn the wheel by hand until the weight position indicator
lights on the side marked
INNER
are
FULLY ILLUMINATED
.
This indicates the position specified by the balancer for the
inner weight position.
5. Attach the specified weight for the INNER position at
top-dead-center. NOTE: To hold the wheel in position when
installing weights, press down on the
SHAFT RESTRAINT
PEDAL
located on the right side of the machine.
NOTE:
All weight positions are located at
TOP-DEAD-CENTER.
The more accurate you are in selecting the exact weight
and position, the more accurate the wheel will be
balanced.
6. After the INNER weight is properly installed, turn the
wheel by hand until the weight position indicator lights on
the side marked
OUTER
are fully illuminated. This
indicates the position specified by the balancer for the
OUTER
weight position.
7. Attach the specified weight for the
CENTER PLANE
position at top-dead-center.
Spin Mode / AL2
1. Once the correct wheel data has been programmed,
lower the hood to begin the spin mode.
2. After the hood is lowered, or the
START
button is
depressed, the wheel will spin for approximately six
seconds then stop automatically.
3. After the wheel stops, weight readings will appear in the
center display screen.
4. Turn the wheel by hand until the weight position indicator
lights on the side marked
INNER
are fully illuminated. This
indicates the position specified by the balancer for the inner
weight position.
5. Attach the specified weight for the
INNER PLANE
at top-
dead-center.
6. After the
INNER
weight is properly installed, turn the
wheel by hand until the weight position indicator lights on
the side marked
OUTER
are
FULLY ILLUMINATED
. This
indicates the position specified by the balancer for the
CENTER PLANE
weight position.
7. Attach the specified weight for the
CENTER PLANE
position at top-dead-center.
Spin Mode / STATIC
STATIC balancing is not an accurate method of balancing and
should be used only when the customer request no visible
weights on the outer edges or plane of the wheel.
1. Once the correct wheel data has been programmed,
lower the hood to begin the spin mode.
13
