Rangemaster Toledo XT 110 Dual Fuel, User'S Manual & Installation Instructions

Page: 21 / 40

17
Control Panel and Doors
Avoid using any abrasive cleaners including cream cleaners.
For best results, use a liquid detergent.
The same cleaner can be used on the doors or alternatively,
using a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance.
After cleaning, polish with a dry cloth.
Ovens
Glass Fronted Door Panels
The oven door front panels can be taken off so that the glass
panels can be cleaned. Move the cooker forward to gain
access to the sides (see the ‘Moving the Cooker’ section under
‘Installation’ ). Open the oven door slightly and remove the
front panel fixing screws from the door sides, two each side
(
Fig.5.5
)
.Carefully lift off the outer door panel. The inside face
of the glass panels can now be cleaned – take care not to
disturb or wet the door insulation.
Note:
If the door is triple glazed then the inner two panels are
fixed together and should not be separated.
After cleaning, carefully refit the outer door panel and replace
the side fixing screws.
n n
DO NOT use harsh abrasive cleaners or sharp metal
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of the
glass.
‘Cook & Clean’ Panels
The ovens have side “Cook & Clean” panels which have been
coated with a special enamel that partly cleans itself. This
does not stop all marks on the lining, but helps to reduce
the amount of manual cleaning needed. These panels work
better above 200 °C. If you do most of your cooking below
this temperature, occasionally remove the panels and wipe
with a lint free cloth and hot soapy water. The panels should
then be dried and replaced and the oven heated at 200 °C for
about one hour. This will ensure the “Cook & Clean” panels are
working effectively.
Do not use steel wool, oven cleaning pads, or any other
materials that will scratch the surface.
Removing the Oven Linings
Some of the lining panels can be removed for cleaning.
If you wish to clean the enamel interior of the oven, you
will need to remove the shelves before removing the ‘Cook
& Clean’ panels. You do not have to remove the support
brackets to remove the panels. Lift each panel upward and
slide forward off the support brackets
(
Fig.5.6
)
.
Once the panels have been removed, the oven enamel
interior can be cleaned.
Refit in the reverse order.
ArtNo.320-0002b
- Oven door side screws (Toledo)
Fig.5.5
Fig.5.6