INSTALLATION
Check the appliance is electrically safe when you have finished.
25
ArtNo.342-0002 - Elan - drawer position
Removing the Storage Drawer
Pull the drawer out to its furthest point
(Fig.7-5)
.
Lift up the ends of the plastic clips (one each side) to release
the catches holding the drawer to the side runners and at the
same time pull the drawer forward and away from the side
runners
(Fig.7-6)
.
For safety’s sake push the drawer runners back out of the way
and put the drawer somewhere safe until the installation is
complete.
Now LOWER THE TWO REAR ROLLERS. First fit the levelling
tool on the hexagonal adjusting nut, at both the front bottom
corners of the cooker
(Fig.7-7)
. Make 10 complete (360°)
turns clockwise
(Fig.7-8)
. (This means turning and removing
the levelling tool 20 times.)
Completing the Move
Unfold the rear edge of the pack base tray. Open the grill
door and right-hand oven door so that you can get a good
grip on the bottom of the fascia panel as you move the
cooker.
Grip under the fascia panel and lift the front of the cooker
slightly
(Fig.7-9)
.
Carefully push the cooker backwards off the pack base.
Remove the pack base tray. Position the cooker close to its
final position, leaving just enough space to get behind it.
DO NOT use the door handles or control knobs to
manoeuvre the cooker.
Repositioning the Cooker following
Connection
If you need to move the cooker once it has been connected,
make sure it is switched off at the supply switch before
gripping under the fascia panel and lifting the front of the
cooker slightly
(Fig.7-9)
. Check behind the cooker to ensure
that the electricity cable is not caught. As you progress,
always ensure that the cable has sufficient slack to allow the
cooker to move.
If a stability chain is fitted, release it as you ease the cooker out.
Do not forget to refit it when you replace the cooker.
When you replace the cooker, check behind it again once
more to ensure that the electricity cable is not caught or
trapped.
ArtNo.010-0010 Lowering the rear rollers (90)
x10
Fig.7-6
ArtNo.010-0002 Rear roller nut
ArtNo.010-0004 Moving the cooker
Fig.7-9
Fig.7-7
Fig.7-8
