Rangemaster RWC 3018 BL, User'S Manual & Installation Instructions

Page: 14 / 24

Door handle
Door frame profile
Door seal
Screws
10
Installing your Wine Cabinet
Installing the stainless steel handle
(
Fig. 4.1
)
• Peel back door seal along the right hand side of door.
You will find a screw hole at the top and lower of the
door where you have peeled the seal back. (please refer
to Fig. 4.1 ).
• Take out the screws and washers from the bag at the
back of the cabinet. Place the washers onto the screws
and then put the screws in the hole where the handle is
to be installed. Please make sure the washer is correctly
in place before you put the screws in the hole.
• Align the handle with screws, tighten the screws using
a screw driver until the handle is both push and secured
tightly against the door side. (
DO NOT
over-tighten as
this may cause damage to the door surface)
• After handle fixed well, put the door seal back to the
door to cover the hole.
Installing the appliance
(Fig. 4.2 & Fig. 4.3)
• Make sure your mains connection is accessible.
• Align the appliance to the height of the recess by
adjusting the adjustable feet.
• Connect the power cord to a conventional socket.
• Slide the appliance into the recess. Make sure the power
cord does not get wedged. The appliance should not be
in direct contact with the floor when sliding into place,
since, this could damage the floor.
Fig. 4.1
300
300
90
70
580
295
575
830 - 890
820 - 880
600
830 - 890
580
820 - 880
595
575
90
70
Fig. 4.2
Fig. 4.3