15
Service alarm
n
n
If an alarm light illuminates, contact an authorised
service centre.
n
n
Press the ‘s.saver’ button to switch the alarm sound
off when there is an alarm and an exclamation mark
on the display. The exclamation mark will continue
to show on the electronic display panel until the
error is fixed.
Temperature Adjustment Warnings
•
It is not recommended that you operate your fridge in
environments colder than 16°C in terms of its efficiency.
•
Do not start another adjustment while you are already
making an adjustment.
•
Temperature adjustments should be made according
to the frequency of door openings, the quantity of food
kept inside the fridge and the ambient temperature in
the location of your fridge.
•
In order to allow your fridge to reach the operating
temperature after being connected to mains, do not
open the doors frequently or place large quantities of
food in the fridge. Please note that, depending on the
ambient temperature, it may take 24 hours for your
fridge to reach the operating temperature.
•
A 5 minute delay function is applied to prevent damage
to the compressor of your fridge when connecting or
disconnecting to mains, or when an energy breakdown
occurs. Your fridge will begin to operate normally after
5 minutes.
•
Your appliance is designed to operate in the ambient
temperature (T/SN = 16°C - 43°C) intervals stated in
the standards. We do not recommend operating your
appliance out of the stated temperature limits in terms
of cooling effectiveness.
NOTE:
If the ambient temperature is higher than 42°C, the
compartment temperature cannot be set to -23°C or -24°C. It
can only be set to -16°C, -17°C, -18°C, -19°C, -20°C -21°C or -22
°C.
88
mode
q drink
s.saver
°c
-88
°c
sensor
freezer
cooler
Hold for
3 seconds
88
mode
q drink
s.saver
°c
-88
°c
sensor
freezer
cooler
Night sensor
This night sensor function saves energy by switching
the lights inside the refrigerator off if there is sufficient
illumination in the room. To activate follow the procedure
below.
Step 1.
Press and hold the
sensor
for 3 seconds.
Step 2.
The night sensor indicator will appear.
Hold for 3
seconds
Summary of Contents for RDXD18IV/C
