WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
33
ArtNo.0102-0011 - Screwing
the control valve bypass screw
A
B
C
ArtNo.311-0010 Injectors
A – Jet, B – Internal injector, C – External injector
Conversion from Natural Gas to
LPG
Check the ‘Technical Data’ section of the instruction book that
the cooker is convertible to the gas you want to use.
In the UK this conversion must be performed by a gas
safe register operative. After conversion the installation
must comply with the relevant regulations and also the
local electricity supply company requirements. Read the
instructions before converting this appliance.
Failure to convert the appliance correctly could invalidate any
warranty or liability claims and lead to prosecution.
This instruction must be used in conjunction with the
appliance instruction, in particular for information on
standards, cooker positioning, connection hose suitability etc.
When servicing or replacing gas-carrying components
disconnect from gas before commencing operation and
check appliance is gas sound after completion.
Do not use re-conditioned or unauthorised gas controls.
Disconnect from the electricity supply before commencing
servicing. Before electrical re-connection, check that the
appliance is electrically safe.
Hotplate Injectors
Remove the burner caps and heads. Remove the old jets
(Fig. 8.1). Fit the new jets (see the back page of this book for
the correct jets).
Reassemble in reverse order.
Bypass Screw Adjustment
The valves in this cooker are fitted with adjustable bypass
screws. The cooker is supplied with the bypass screws set for
Natural gas. For LPG conversion the bypass screws must be
screwed all the way down.
Turn the bypass screw on each hotplate control clockwise to
the stop (Fig. 8.2).
It may is possible to adjust the bypass screw by simply
removing the control knobs (Fig. 8.3).
If however you are unable to access the bypass screw using
a suitable screwdriver, you will need to remove the control
panel, please refer to section ‘Removing the Control Panel’.
8. All Gas - Conversion to LPG
Fig. 8.1
Fig. 8.2
Fig. 8.3
