35
17. To Change Oven Door Seal
Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal
diagonally away from the door centre until that hook
is released. Proceed to the next hook and release it
in a similar way, and so on.
Fig. 4
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes
of the door, and proceed round the door snapping in
each hook in turn.
18. To Adjust Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep,
and screw in or out as required until required fi t is
obtained. Retighten locking nut.
19. To Change Ignition Generator
Disconnect from electricity supply.
Pull cooker forward to gain access to the cover box at
the rear of the left hand cooker. Remove the screws
securing the cover and lift clear. Pull off all the leads
to the generator noting their positions. Slacken the
two screws holding generator to cooker and remove
generator.
Fit new generator to cooker and replace leads.
Reassemble in reverse order. Refer to wiring
diagram. Check ignition performance.
20. To Remove Oven Inner Back.
Open the oven door. Remove oven furniture. For
the LH oven unscrew the 2 thermostat phial fi xing
screws.
Remove the fi xings that secure the inner back to the oven
rear.
Lift the removable panel away. Re-assemble in
reverse order. Ensure that the retaining fi xings
are fully tightened. For the LH oven unscrew the 2
thermostat phial fi xing screws. Remove the screws
that secure the inner back to the oven rear. Lift the
removable panel away. Re-assemble in reverse order.
Ensure that the retaining fi xings are fully tightened.
22. To Replace an Oven Fan
Disconnect from electricity supply.
Pull the unit forward to access the cover boxes at the
rear of the appliance. Remove the fi xings that secure
the cover and lift it clear. Remove the fan wiring,
noting the connection positions. Remove the inner
back as detailed in Section 20. Hold the fan blades
and undo the centre nut (LH thread), brass washers,
fan blade and Circlip. Undo the fi xings that retain
the fan and remove it from the cavity rear. Fit the
replacement and re-assemble parts in reverse order.
Check that the oven operates satisfactorily.
23. To Remove an Oven fan Element
Disconnect from electricity supply.
Remove the inner back as detailed in Section 20.
Remove the fi xings that secure the element within the
oven and lift the element away carefully. Disconnect
the leads and connect to the replacement element
and re-assemble parts in reverse order. Check that
the oven operates correctly.
Summary of Contents for ELAN U105510-01
Page 1: ...110 Ceramic Users Guide Installation Service Instructions U105510 01...
Page 38: ...38...
Page 40: ......