Rangemaster ELAN U105510-01, Installation And User Manual

Page: 23 / 40

23
Moving your cooker
Switch off the electricity supply.
The cooker is heavy; two people may be
required to move it. The cooker is fi tted with
one roller at the front and two at the back.
There are also two screw down levelling feet
at the front.
The front roller, designed for moving the cooker
can be wound down. The levelling tool that
controls this roller is in the storage drawer.
To remove the drawer, pull it right out
Lift up the ends of the plastic clips (one each
side) to release the catches holding the drawer
to the side runners and at the same time pull the
drawer forward and away from the side runners.
For safety’s sake push the drawer runners back
out of the way.
Locate levelling tool as shown. If you cannot
fi nd the levelling tool, contact your installer. See
the start of the ‘Installation’ section of these
instructions.
Turn the levelling tool clockwise, two full
(180°) turns. It will be stiff. The front of the
oven will rise slightly as the roller drops
down.
Open the grill door and right hand oven door so
that you can get a good grip on the bottom of
the fascia panel as you move the oven.
Do not move the oven by pulling the hand
rail, door handles or knobs.
Move the oven a bit at a time, checking behind it
to make sure the cable is not caught. Make sure
the electricity cable has suffi cient slack to move
the cooker forward as you go along.
If a stability chain is fi tted, release it as you
ease the cooker out.
When you replace the cooker, wind it down
off the rollers by turning the levelling tool anti-
clockwise. This is important. It will stop the
cooker moving accidentally, while in use.
To refit the draw
Pull out the side runners. Rest the drawer back
on the side runners and, keeping it level, push
it right back. The clips should click into position
holding the drawer to the side runners.