SERVICING WARNING
Disconnect from electricity supply before servicing. Check ap pli ance is safe when you have finished.
34
7. To
Remove
a
Thermostat
Lift up the ceramic hob top (see 2). Remove control
panel (see 4). Open appropriate oven door and
remove oven furniture.
Main oven
Remove thermostat phial cover (2 screws). Unclip the
thermostat phial from the clips in the oven back.
Tall oven
Pull cooker forward to gain access to the cover box at
the rear of the cooker. Remove the screws securing
the cover and lift clear.
Feed the thermostat capillary out of the oven.
Disconnect wiring from thermostat. Remove 2 screws
holding thermostat to mounting panel. Fit new
thermostat and reassemble in reverse order. Ensure
that the phial is clipped to the oven back with the
phial centrally positioned between the clips.
Check operation of thermostat.
8. To Change Grill Controller
Lift up the ceramic hob top (see 2). Remove control
panel (see 4). Disconnect wiring from controller.
Remove 2 screws holding controller to mounting
panel. Fit new controller and reassemble in reverse
order. Check for correct operation.
9. To Remove Grill Door
Remove the left hand side panel (see 1). Remove the
control panel (see 4). Remove the centre cover strip
(5 screws, 2 top, 2 bottom, 1 in middle). Remove the
two countersunk screws (1 each side) securing the
grill hinge arms to the front of the grill chamber.
NOTE: The arms are spring tensioned. Carefully
remove the grill door. Retain the gaskets.
Reassemble in reverse order ensuring that the
gasket is fi tted between the hinge arm and the front
of the grill chamber.
10. To Remove Main Oven Door
Open oven door and remove Handyrack (where
fi tted) by springing one side out of the bracket on the
door and sliding the other side free. Support the door
and remove the two screws securing the upper hinge
and packing to the cooker front. Remove the door
from the lower hinge by lifting slightly and moving
outwards.
Reassemble in reverse order.
11. To Change Main Oven Door Outer Panel
Remove the two plastic blanking plugs from the
door handles. Remove the 4mm Hex headed screws
holding the handle to the door with the hexagon key
tool. Remove two screws from top edge and two from
bottom edge of the door.
Remove outer door panel. Fit door handle to new
panel. Fit the plastic blanking plugs to the fi xing
holes.
The handles should be above the fi xings.
Fit panel to door. Reassemble in reverse order
12. To Change Main Oven Door Latch
Remove outer door panel (see 10). Remove screws
‘B’ holding latch assembly to inner door panel. Fit
new catch and reassemble in reverse order.
Check correct door operation.
