Rangemaster Classic 90 Dual Fuel - 3 Button Clock, User'S Manual & Installation Instructions

Page: 20 / 40

16
ArtNo.331-0003 Grill frame out, no pan
ArtNo.331-0004 Removing the grill frame
ArtNo.331-0005 Removing the grill rail
ArtNo.331-0006 Grill pan plan
Fig. 7.5
Fig. 7.6
Fig. 7.7
Fig. 7.8
The Griddle
Always clean the griddle after use. Allow it to cool completely
before removing. Immerse the griddle plate in hot soapy
water. Use a soft cloth or, for stubborn stains, a nylon washing
up brush.
NOTE
: If the griddle is washed in a dishwasher then some
dishwasher residue may appear on the back. This is normal
and will not affect the performance of your griddle.
Glide-out Grill
n n
Before you remove any of the grill parts for cleaning.
make sure that they are cool, or use oven gloves.
n n
DO NOT use any abrasive sunstances.
The grill pan and trivet should be washed in hot soapy water.
Alternatively, the grill pan can be washed in a dishwasher.
After grilling meats or any foods that soil, leave to soak for
a few minutes in the sink immediately after use. Stubborn
particles may be removed from the trivet using a nylon brush.
The grill pan can be easily removed for cleaning as follows:
Remove the grill pan support frame by pulling the grill pan
forward.
Lift the grill pan clear of the support frame. The support frame
is held to the side rails by two clips on each side (
Fig. 7.5
).
For each side, support the side rail with one hand and with
the other hand lift the frame up and out of the side clips
( Fig. 7.6 ).
For safety, push the side rails back into the grill chamber.
If you need to remove the side rails to allow cleaning of the
grill chamber, you can unhook them from the grill chamber
sides ( Fig. 7.7 ) and wipe the sides clean with a soft cloth and
mild detergent.
n n
DO NOT put the side runners in a dishwasher.
Once you have finished, hook the side rails back onto the
sides of the chamber. To refit the frame, pull the side rails
forward and, for each side in turn, support the side rail and
press the frame down into the side rails. Replace the grill pan.
When refitting the grill pan, make sure that the wide rim is at
the front ( Fig. 7.8 ).
Control Panel and Doors
Avoid using any abrasive cleaners including cream cleaners,
on brushed stainless steel surfaces. For best results, use a
liquid detergent.
The control panel, knobs and doors should only be cleaned
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance.
After cleaning, polish with a dry cloth.