Rangemaster Arleston 60 Gas, User Manual

Page: 20 / 24

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
18 18
Check the ‘ Technical Data ’ section at the back of the book
that the hob is convertible to the gas you want to use.
A suitably competent person must perform the
conversion. After conversion the installation must
comply with the relevant regulations and also the local
electricity supply company requirements. Read the
instructions before converting this appliance.
n n
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead
to prosecution.
n n
When servicing or replacing gas-carrying
components disconnect from the gas supply before
starting operation. Check the appliance is gas sound
after completion.
n n
DO NOT use reconditioned or unauthorised gas
controls.
n n
Disconnect from the electricity supply before
servicing.
n n
Before electrical reconnection, check that the
appliance is electrically safe.
Hotplate
Remove the burner caps and heads. Remove the old jets
(Fig.8-1) . Fit the new jets (see ‘ Technical Data ’ section at the
back of the book for correct jets). Reassemble in the reverse
order.
Bypass Screw Adjustment
Pull of the control knobs.
Remove the three screws located beneath the control panel
and remove the plate. Then remove the additional two
screws, now visible.
Gently pull off the control panel. The bypass screw is located
on the side of the valve spindle (Fig.8-2) .
Turn the bypass screw on each control clockwise to the stop
position.
Reassemble in the reverse order.
Changing the Grill Burner
Remove the screw securing the grill burner to the oven cavity.
Gently Pull the burner to reveal the injector at the back.
Using a 7mm box spanner carefully remove the injector and
replace with the new one.
Reassemble in the reverse order.
A
Fig.8-1
A – Jet
Fig.8-2
8. Conversion to LP Gas