10
②
Gear (turn table)
1
Greasing coating
Every 30 working hours
③
Drive chain(turn table)
1
oil
After use
④
Drive chain(automatic
stopping device)
1
oil
After use
⑤
Slide arm screw(automatic
stopping device)
1
oil
After use
⑥
Side arm shaft face
(automatic stopping device
1
oil
After use
⑦
Gear (stretching device)
1
Grease coating
Every 30 working hours
Bearings and other sliding
portions
----
Grease or oil
After use
※
1.For the detail of oiling to the engine(No.1), see the instruction manual for the engine
contained in the package.
※
2.If the slide arm shaft face
（
automatic stopping device)(No.6) is coated with a grease
with a high viscosity,the movement of the slide arm becomes poor.
3.How to operate
1.Purpose of machine
1.this machine is used to stretch and wind a film around a cylindrical bale for sealing it,to
prepare bale silage for livestock farming.Do not use the machine for any other application.
2.To prepare silage of good quality,do not operate the machine in the case where the
grass contains much water due to rainfall or dense fog,or on a muddy field or highly humid
field. Wrap the grass with an adequate water content on a well dry field as soon as
possible after baling.
1.Adjust the water content of grass to 50 to 60%.if the water content is too large or too small,ideal lactic
acid fermentation cannot take place.Especially during rainfall or dense fog,do not operate the machine
since the mater content is too large
2.Preparation of well-shaped highly dense bales.Make well-shaped highly dense bales
3.Sealing immediately after baling.If the sealing is delayed,the temperature inside the bale rises to grow
putrefying bacteria and to thermally denature proteins,thereby lowering the digestibility,not allowing
silage with good quality to be prepared.
4.Use a wrapping film with stable quality.A film like to greatly change in nature in response to the change
of air temperature may be poor in the accuracy of sealing.Preserve the film in a cool place free from
direct sunshine,to avoid the deterioration during preservation.Do not preserve the film for a long period of
time.
5.If the film used for sealing is damaged to have a hole,be sure to repair it.If a film is
damaged or holed by mistake,be sure to repair it.If an ordinary tape is used for repairing ,it
may peel due to water content,solar heat or the like.Use the repair film designated by us
6.Reliable preservation
As the place for preserving the silage,select a well drained place and cover the silage
with a net,or spray chemicals, or take any other necessary measure for protecting the
For perparing wrapped silage with good
