OWNER’S MANUAL
14
TTM57mkII
Main and Booth
The Main and Booth outputs each have their own
LEVEL
control. The Main outputs
use balanced XLR connectors and the Booth outputs use balanced ¼˝ TRS
connectors. Since the Main, Booth and Session Outputs have the same Mix, you can
run any of them to your main amplifier if the proper cables are not available.
The Main Mix section has a quasi-peak stereo meter with peak hold. The Main Mix
can be set to Stereo or Mono in the Rane Control Panel. Booth and Session Outputs
are always in stereo. See the "General Control Panel" on page 21.
Headphone Cue
Deck 1, Deck 2, and USB Aux can each be cued in the headphones before bringing
into the mix. USB Aux has it's own
CUE
AUX
button. The Deck cues are
determined by a slide control, as they were on the original TTM57SL.
• The Headphone monitor provides stereo or mono split cue operation.
•
When set for stereo operation (
SPLIT CUE
button off), the
PAN
control pans
between stereo Cue and stereo Main Mix.
•
When set for Split Cue operation (
SPLIT CUE
button On), the
PAN
control pans
between Mono Cue in the left ear and mono Main Mix in the right ear.
• The
PHONES
control sets the volume sent to the headphone jacks.
• The
CUE
slider cues Deck 1 or Deck 2 by moving the slider accordingly.
• Headphone ¼" and 3.5 mm jacks are on the front panel. Both share the same mix.
Channel Faders & Crossfader
These faders use magnetic non-contact mechanisms with no noise and no bleed.
Each fader has
REVERSE
and
CONTOUR
controls. Normally, Deck 1 is routed to the
left fader and left side of the crossfader, while Deck 2 is routed to the right. When activated,
CHANNEL
SWAP
puts Deck 1 on the right, and Deck 2 on the left. See "Magnetic Fader Maintenance" on page 30.
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
10
0
2
4
8
6
MAIN
CUE
MIX
PHONES
PAN
SESSION OUT
BOOTH
MAIN
DECK 1
CUE
DECK 2
SPLIT CUEING
A
B
DECK 1
CROSSFADE
CHANNEL SWAP
REVERSE
REVERSE
REVERSE
DECK 2
